User manual

Spectrum Z510 User Manual
29 www.zcorp-users.com
4.4 Checking Build Settings
ALWAYS check build settings before
printing:
1. Choose the ‘3D Print Setup’ option
from the File menu (or toolbar).
2. Check that the selected printer,
powder type, and powder settings for
the build are correct. The software
settings are the recommended
values.
3. If the settings need to be changed,
select ‘Override’. Press ‘OK’ to
confirm.
For more information on how to change
the settings, please refer to the ZPrint
Software User Manual.
 It is also strongly recommended that
slice viewing and collision detection
(if more than one part is being
printed) be used before beginning
the build. These features are found
under the View menu of the
software.
 Slice viewing allows you to view the
cross sections of the part to identify
any errors in the file.
 Collision detection will scan through
the slices and report the layer in
which part overlapping is found.