User manual

Spectrum Z510 User Manual
www.zcorp-users.com
20
10. Close the top cover.
Fill build area with
powder by pressing
and holding the
‘Spread’ button on
the control panel for
four complete
spreads. This will
initiate the “Fill Bed”
mode. The LCD will
display “Filling bed;
Online to cancel.”
11. Lift top cover and vacuum loose
powder from area surrounding
feed and build box.
3.2 Cleaning the Service Station
The service station cleans the array of the print heads during printing. The service station
MUST be cleaned before every build. This will remove any deposits of powder. Make sure
parking caps are dry before beginning the build.
1. Select “Unpark” from the Service
Menu in ZPrint Software, which
will move the carriage out of the
parking position, allowing
access to the service station.
Technical Tip -
Keep powder containers closed when not in use to keep powder dry.
Scoop powder carefully to minimize airborne powder.
Make sure that you carefully vacuum up excess powder. It only takes a minute, and the tidier
the machine is, the less often it will need maintenance!
Carefully read the Material Safety Data Sheet for powder before use.