Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Appendix
www.3dpuser.com
vi
10/1/07 All Rights Reserved
Selecting SAVE AND EXIT displays: SAVE AND EXIT
Press the < Feed UP > key to save your changes and terminate the
Configuration menu.
Selecting DISCARD AND EXIT displays: DISCARD AND EXIT
Press the < Feed UP > key to terminate the Configuration menu. Your
changes for the current session will not be saved.
11.2 Error Codes
PLEASE NOTE: %d is a placeholder for numbers corresponding either to a print head
number or a value. Contact our Service Department at [e-mail]
if you need
additional help.
Error Code
LCD Display
1000, PRINTHEAD ERROR)
1001, PRINTHEAD POWER FAIL)
1003, PRINTHEAD %d ERROR)
1004, PRINTHEAD POWER FAIL)
1005, PRINTHEAD %d ERROR)
1006, PRINTHEAD %d OVERTEMP)
1007, PRINTHEAD POWER FAIL)
1009, PRINTHEAD POWER FAIL)
1010, PRINTHEAD %d ERROR)
1802, USE SERIAL PORT)
1905, LAYER TOO BIG)
2303, AXIS %d ERROR)
2304, AXIS %d ERROR)
2305, AXIS %d ERROR)
2400, AXIS %d REZERO ERROR)
40006, CLEAN SENSOR WINDOW)
40007, ALIGNMENT FAILED)
40008, ALIGNMENT FAILED)
40204, MOTOR DRIVE OVERLOAD)
40205, MOTOR DRIVE OVERLOAD)
40207, 24V FAIL)
40208, MOTOR DRIVE OVERLOAD)
40800, PRINTHEAD %d ERROR)
40801, HEADCARD POWER FAIL)
40802, PRINTHEAD %d NOT HP11)
40901, TEMP SENSOR FAILED)
40902, TEMP OUT OF RANGE)