Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Appendix
www.3dpuser.com
v
10/1/07 All Rights Reserved
Press the < Feed UP > key to move the cursor to the right.
Press the < Feed DN > key to move the cursor to the left.
Press the < Build UP > or < Build DN > keys to change the value at
the current cursor position.
• If the cursor is at the rightmost IP ADDRESS field, and the
< Feed UP > key is pressed, the LCD display reads:
SUBNET MASK
0.
0. 0. 0.
Press the < Feed UP > key to move the cursor to the right.
Press the < Feed DN > key to move the cursor to the left.
Press the < Build UP > or < Build DN > keys to change the value at
the current cursor position.
If the cursor is at the rightmost SUBNET MASK field and the
< Feed UP > key is pressed, you are returned to the Configuration
menu.
If the cursor is at the leftmost SUBNET MASK field and the
< Feed DN > key is pressed, you are returned to IP ADDRESS.
• If the cursor is at the leftmost IP ADDRESS field, and the
< Feed DN > key is pressed, the LCD display reads:
DHCP/STATIC IP
USE DHCP? YES
Press the < Build UP > or < Build DN > keys to toggle YES/NO.
If YES is selected and you press the < Feed UP > key, you are
returned to the Configuration menu.
Selecting RESTORE FIRMWARE displays: RESTORE FIRMWARE
RESTORE FIRMWARE? NO
Press the < Build UP > and < Build DN > keys to toggle YES/NO.
YES means the printer will use the previous version of firmware prior
to the firmware you just installed.
Press the < Feed UP > key to return to the Configuration menu.
Selecting DIAGNOSTIC MODE displays: DIAG MODE?
DIAG MODE? NO
Press the < Build UP > or < Build DN > keys to toggle YES/NO.
NO is normal operation. YES will skip the rezero calibration (fast,
slow axis and pistons) for the current session and causes the pistons
to rezero on the next powerup.
Press the < Feed UP > key to return to the Configuration menu.