Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Appendix

www.3dpuser.com

11 Appendix

11.1 Restoring Network and Firmware Settings

Configuration mode is obtained by pressing and holding the ONLINE key on the printer control panel.

Configuration mode is indicated when the LCD displays: NETWORK SETTINGS

The Configuration menu consists of these 5 choices: NETWORK SETTINGS

RESTORE FIRMWARE

DIAGNOSTIC MODE

SAVE AND EXIT

DISCARD AND EXIT

Press the < Build UP > or < Build DN > keys to scroll through the

Configuration menu.

Press the < Feed UP > key to select an item on the Configuration

menu to edit. The LCD displays your selection.

Selecting NETWORK SETTINGS displays: NETWORK SETTINGS

USE NETWORK? YES

Press the < Build UP > or < Build DN > keys to toggle YES/NO.

Selecting NO means the serial port will be used.

Press the < Feed UP > key to display:

DHCP/STATIC IP

USE DHCP? YES

Press the < Build UP > and < Build DN > keys to toggle YES/NO.

If NO is selected, and the < Feed UP > key is pressed, the LCD dis-

plays:

IP ADDRESS

0. 0. 0.