Hardware manual

Spectrum Z™510 3D Printer Hardware Manual 3D Printer System Details
www.3dpuser.com
69
10/1/07 All Rights Reserved
10.2 Symbols Used
10.3 Description of Rear Panel
Serial Port Connection
This is an RS-232 serial port for data transfer to and from the ZPrint software. The 3D Printer uses 115k
baud and has the same pin out as a standard PC compatible computer. The connection to the Windows
computer running the software requires a 9 pin to 9 pin null modem cable (also known as a 'laplink' cable).
This cable is supplied with your 3D Printer System; if a replacement is required, order Z Corporation part
#10267.
Diagnostic Connections (Video and keyboard)
These connections are used while servicing your 3D Printer System. Nothing should be connected to
them in normal operation. The diagnostic video connection is standard VGA output video. The keyboard
connection is PS/2 style compatible.
Ethernet Connection
An Ethernet connection allows the printer to be network compatible. For more information contact the Z
Corporation Service Department at [phone] or via email at [e-mail]
.
Material Storage Precautions
This is the international symbol for Warning or
Caution. It indicates the need to consult your
manual for further information.
It is located on the rear, lower left side of your
printer to call your attention to the fact that only
trained personnel should open the 3D Printer
rear cover. None of the normal operation proce-
dures described in this manual requires you to
remove this cover.