Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Troubleshooting
www.3dpuser.com
65
10/1/07 All Rights Reserved
8. Close the printer top cover and select Service > Auto Alignment in ZPrint.
9.8 Air has Entered into the Wash Fluid Line
You will need to use the Prime Wash Fluid feature when there is no wash fluid or air has entered the fluid
line. This can occur in a few instances such as when first installing the Printer, when running out of wash
fluid, or when the connection to the fluid line has been disconnected. Air can be easily detected by looking
to see if there are air bubbles in the fluid line. To remove air from the fluid line, follow the instructions below:
1. Place the printer Online.
2. Select Prime Wash Line on the Service menu.
3. Click Start.
4. The Prime Wash Fluid status box will close when priming is completed.