Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Service Menu and Other Maintenance
www.3dpuser.com
54
10/1/07 All Rights Reserved
• Visually inspect the lines where they connect to the Carriage to see if air bubbles are present.
Follow the procedure below if you see air in one or more of the binder lines.
1. In ZPrint, select Service > Bleed Air > Start to move the carriage to the front of the printer where you
have easy access to the carriage.
2. Open the carriage cover and remove the print heads for each binder line that has air bubbles present.
3. Use an alcohol crush swab to wipe the pogo pins clean for each removed print head.