Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Service Menu and Other Maintenance

www.3dpuser.com

12. When purging is completed, return to the Service menu and select Auto Alignment.

13. The printer will print out an alignment pattern. The first several layers will be gray-based and then the

color alignment pattern is printed.

14. The last part of the color alignment pattern that is printed is a bulls-eye pattern for you to confirm that

all print heads are aligned. A good alignment will look like the example below where the color does not

overlap into the red circle. If the alignment is not good, try cleaning the sensor window again and re-

run the Auto Alignment. If the pattern still fails, call your local service provider.

Please Note: You may wish to start a build while the print heads are aligning. To do so, click Cancel

to close the Auto Align dialog. The part builds on top of the alignment pattern. If you choose to

begin a build before the alignment is finished, you will be unable to confirm the bulls-eye pattern for

proper print head alignment.