Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Post-Processing the Part

www.3dpuser.com

7.5 Drying the Part

Although the part can be handled when it is not completely dried, the part reaches full strength when dried.

Placing the part in an oven at temperatures less than 200

° F (93°C) for 2-4 hours will dramatically increase

the strength of the part. This is only recommended for high definition composite powders. If using the

removable build plate, remove the part from the build plate before placing in the oven.

Click the following links for additional information on our 3DP™ User website regarding:

Accessories

Frequently Asked Questions regarding Ovens

Despatch Oven General Description

7.6 Part Infiltration

All parts can be infiltrated with a variety of resins to produce a range of material properties. As an early

stage design tool, it may not be necessary to infiltrate the parts at all. However, the true versatility of the

Z510 3D Printer System is derived from the variety of material properties that can be achieved by applying

one of our infiltration materials to parts that will be exposed to a variety of product testing environments.

For additional information on how customers are utilizing our line of infiltration products visit our 3DP™

User website at www.3dpusers.com

For an updated infiltrant product selection guide, please visit the 3DP™ User Website at

www.3dpusers.com

, or click one of the links in the table below.

To learn more about finishing moving parts, finishing color parts, and finishing a part using the dipping

method, click Application Resources

and view additional applications information on the 3DP™ User web-

site.

INFILTRANTS MATERIAL SYSTEM APPLICATION

Wax High Composite Material Dip

Z-Bond™ Cyanoacrylate High Composite Material Brush or Drizzle

Z-Max™ Epoxy High Composite Material Spray or Brush