Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Post-Processing the Part

www.3dpuser.com

6. To gain access to the sides of the parts, raise the build piston by holding down the Build UP button.

7. When finished, you may remove the part by hand or press the Build UP button on the control panel.

When it stops moving, press Build UP one more time to initiate the unload feature. The build plate will

now be exposed and easy to lift off the build envelope.

8. Place a tray on the top of the feed area. Remove the build plate and place on the tray. The part is now

ready to be fine depowdered.

WARNING

When performing any vacuuming operation, use

the vacuum provided as part of the 3D Printer

System. Vacuuming powder can generate static

electricity, and use of a non-grounded vacuum

will create static charges, which may affect the

operation of the 3D Printer System and harm

the operator.