Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Routine Operations

www.3dpuser.com

2. With the Service Station exposed, rinse rubber Parking Cap with distilled water (If needed, remove

rubber Parking Caps and rinse under running water). Wipe dry with paper towel.

PLEASE NOTE: Make sure the Parking Caps are sitting flat in their holders.

3. Clean squirt manifold holes by carefully inserting the luer lock needle into the squirt manifold holes. DO

NOT PRESS HARD. The needle should go in. Clean one by one all six holes. Be careful not to scratch

or score holes.

4. Rinse rubber wiper blade with distilled water and wipe dry with paper towel. Ensure that there is no

powder buildup anywhere in the proximity of the rubber wiper.