Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Troubleshooting
www.3dpuser.com
63
10/2/07 All Rights Reserved
9.8 Air has Entered into the Wash Fluid Line
You will need to use the Prime Wash Fluid feature when there is no wash fluid or air has entered the wash
fluid line. This can occur in a few instances such as when first installing the Printer, when running out of
wash fluid, or when the connection to the fluid line has been disconnected. Air can be easily detected by
looking to see if there are air bubbles in the wash fluid line. To remove air from the line, follow the instruc-
tions below:
1. Place the printer Online.
2. Select Service > Prime Wash Line.
3. Click Start.
4. The Prime Wash Fluid status box will close when priming is completed.