Hardware manual

Spectrum Z™510 3D Printer Hardware Manual Service Menu and Other Maintenance

www.3dpuser.com

5. Raise and lower both the feed and build pistons a couple of times to evenly distribute the grease. Any

excess grease should be wiped off with a paper towel.

8.8.4 Cleaning the Fast Axis Rails and Bumpers

1. Select Service > Unpark. After the Carriage is unparked, you can manually move it in order to clean.

2. Place the printer in Offline mode and open the printer top cover.

3. Locate the rubber bumper at each end of the Fast Axis. Wipe away any grease you see on the

bumper. Be sure to clean both bumpers.Thoroughly clean the Fast Axis rail of any visible grease.

4. Manually move the Carriage back and forth and wipe the entire axis clean.