User's Manual

4. PPTP

a) My IP Address and My Subnet Mask: the private IP Address and subnet

mask that your ISP assigned to you.

b) Server IP Address: the IP Address of the PPTP server.

c) PPTP Account and Password: the account and password that your ISP

assigned to you. If you don't want to change the password, leave the

field empty.

d) Connection ID: optional. Input the connection ID if your ISP requires it.

e) Maximum Idle Time: the time of no activity to disconnect your PPTP

session. Set it to zero or enable Auto-reconnect to disable this feature.

If Auto-reconnect is enabled, this product will automatically connect to

ISP after system is restarted or connection is dropped.

4.4 Primary Setup

These core options are essential to enable the AP to work properly. The

available settings and the interface depend on the WAN type. Choose correct

WAN type before you start.

4.4.1 LAN IP Settings

1. LAN IP Address Type:

Two selections are provided. If you plan to use any external DHCP server,

first enter the settings on the DHCP server page and disable the default

DHCP sever, and then return to this page and select Dynamic. Otherwise

set the LAN address to Static and make sure the IP address is in the range

of the DHCP server where the default DHCP server is usually enabled.

2. LAN IP Address:

The local IP Address of this device. Normally the computers on your network

use the LAN IP Address of your product as their Default Gateway. You can

change it if necessary.

3. Subnet Mask: