User's Manual

3-2-1-2 Wireless Client

Select Wireless Client in the Operation Mode field to display the screen as shown next. This

mode has the device act as wireless client to connect to a wireless network.

Note: WPA, WPA2 and IEEE 802.1x wireless security are not available when you use Wireless

Client, Bridge or AP+Repeater mode.

Basic Settings

Operation Mode: Selecte the operating mode from the drop-down list. The options are Access

Point, Wireless Client, Bridge, AP+Repeater.

SSID: The SSID is a unique ID used by Access Points and Stations to identify a wireless LAN.

Wireless clients associating to any Access Point must have the same SSID. The default SSID is

“Wireless”. To change the SSID, type in the SSID you like to use. It is case sensitive and must not

exceed 32 characters.

Wireless Mode: There are three different wireless modes to operate, “Auto (11g/11b)”, “802.11b

only”, and “802.11g only”. In Auto (11g/11b) mode, the access point is compatible with a mix of

both 802.11g and 802.11b clients. You will see that the factory-set default “Auto (11b/11g)” will

prove the most efficient. 802.11b only mode is compatible with 802.11b clients only. This mode

can be used only if you do not allow any 802.11g clients to access to the network. 802.11g only

mode is compatible with 802.11g clients only. This mode can be used only if you do not allow any

802.11b clients to access to the network. To switch the mode, select the desired mode form the

pull-down menu next to “Wireless Mode”.

Site Survey: Press Site Survey to find the active Access Point.

Advance Settings