User manual

Chapter 5 Management Page 54
Enter “help” command to get setting information; alternatively, you can refer to Appendix C. SSH
Settings for details.
SNMP
The R2 Extender supports SNMP management. Set the SNMP parameters and obtain MIB file before
remote management.
From “Remote Management” in “Management”, set the parameters for SNMP:
- Enable SNMP by checking “Enable”;
- Specify the “Read Community Name”, “Write Community Name” and “IP Address to Receive
Traps”
- Hit “Apply” to save settings.
Obtain MIB file via FTP:
- Enter ftp 192.168.1.1 , username (Default: admin) and password (Default: password);
- After successful login, enter command “get bridge.mib”, the information will as below and then
bridge.mib file is obtained.
Figure 43 Obtain MIB File