User manual

Chapter 3 Basic Settings Page 31
Wireless Device Name
Specify the device name, which is composed of no more than 15 characters with (0-9), (A-Z), (a-z) or
(-).
Country/Region
For the available radio bands vary from country to country, the working channels used are different.
Ethernet Data rate
Specify the transmission rate of data.
IP Address
If you select “Manual”, you have to specify a static IP address, subnet mask, default gateway and
DNS server for your local area network which connects to the LAN port of R2 Extender. Make sure
the specified IP address is unique on your network in order to prevent IP conflict.
DHCP Client
Enable DHCP client to allow the DHCP server within your local area network to assign an IP address
automatically.
Spanning Tree Protocol (STP)
Spanning Tree Protocol is a link management protocol for RCP bridges which provides path
redundancy while preventing loops in a network. STP allows only one active path at a time between
the RCP bridges but establish the redundant link as a backup if the initial link fails.
STP Forward Delay
STP Forward Delay is the time spent in detecting and learning network tree topology state before
entering the forward state. Default time value is 1 sec. Select Normal if you would like to modify the
parameter (4-30 seconds).
Link Aggregation
Link Aggregation combines two physical network links into a single logical link for increased
bandwidth. Besides, it provides load balancing.