User manual

Chapter 3 Basic Settings Page 27
Chapter 3 Basic Settings
Factory Default Settings
We’ll elaborate the R2 Extender factory default settings. You can re-acquire these parameters by
default. If necessary, please refer to the “Restore Factory Default Settings
”.
Table 2 R2 Extender Factory Default Settings
Features Factory Default Settings
Username admin
Password password
Wireless Device Name DEVICEXXXXXX (X represents the
last 6 digits of Ethernet MAC
address)
Operating Mode Peer-to-Peer (CSMA)
Country/Region United States (Country dependent
and software programmed)
Ethernet Data Rate Automatic
LAN
IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Gateway 0.0.0.0
Primary DNS Server 0.0.0.0
Secondary DNS Server 0.0.0.0
DHCP Client Disable
Spanning Tree Enable
Link Aggregation Disable
Wireless Mode 802.11a
Channel/Frequency 149/5.745GHzʳ(CE: 100/5.5GHz)
BSSID wireless
Transmit Rate Best
Output Power 100% (Full)
Bandwidth 20MHz
TDM Coordination Disable
WMM Disable
Super Mode Disable
RTS Threshold (byte) 2346
Fragmentation Length (byte) 2346
Beacon Interval 100
Distance in Meters 10000
Security Open System
Encryption None