User manual

Chapter 2 Hardware Installation Page 25
Power On
To power up the R2 Extender, follow the steps bellow:
1. Plug a user-supplied Cat-5 Ethernet cable from your wired LAN (or a computer) into the power
injector RJ-45 jack (DATA IN);
2. Plug a user-supplied Cat-5 Ethernet cable from the R2 Extender into the power injector RJ-45 jack
(P+DATA OUT);
3. Connect the power module to the power injector and plug the AC cord into an AC power
receptacle;
4. After being powered on, the device will send out the beep sound lasting about 1.5 seconds,
informing you that the R2 Extender is powered up! Wait for about 60 seconds the system will be
initialized and start working!
Figure 18 PoE Connection
Make sure PoE is correctly connected to the RJ-45 port on the R2 Extender labeled
PoE+Data, otherwise the extender will be severely damaged!
Warning: