User manual

Chapter 2 Hardware Installation Page 19
Hardware Installation
Assemble the Mounting Bracket
1. Place the main bracket into the seating and use a spanner to fasten the bracket to the R2
Extender with M5×16 screws ľ and M5 washers Ŀ provided in the hardware packets;
Figure 4 Bracket Mounting – Step 1
2. Assemble the main bracket by placing articulation pole ĸ to the T-form bracket ķ via a
M8×90 ĺ screw through the insertion axe and fix with the M8 washer Ļ , spring washer ļ
and M8 nutĽ;
Figure 5 Bracket Mounting – Step 2
Pole Mounting
1. Install the main bracket and the pole mount bar Ĺ over the top of the pole by securing the
drill holes of the pole mount bar to the main bracket ones and insert two M8×80 ĺ screws,
spring washers ļ and washers Ļ through the drill holes and main bracket;