User manual

Chapter 5 Management Page 57
Figure 41 SSH
Enter the user name and password (Default user name/ password: admin/password)
respectively, you will see “DEVICE123456>”, which is the name of R1 Extender;
Enter “help” command to get setting information; alternatively, you can refer to Appendix C. SSH
Settings for details.
SNMP
The R1 Extender supports SNMP management. Set the SNMP parameters and obtain MIB file before
remote management.
From “Remote Management” in “Management”, set the parameters for SNMP:
- Enable SNMP by checking “Enable”;
- Specify the “Read Community Name”, “Write Community Name” and “IP Address to
Receive Traps”
- Hit “Apply” to save settings.
Obtain MIB file via FTP:
- Enter ftp 192.168.1.1 , username (Default: admin) and password (Default: password);