User manual

Chapter 5 Management Page 46
Access Control
The Access Control appoints the authority to STA on accessing R1 Extender, thus a further security
mechanism is provided. This function is available only under Base Station mode.
Open “Access Control” in “Wireless” as below, check “Turn Access Control On” to enable this
function.
Figure 31 Access Control
Available CPEs
In this table lists the CPEs connecting with R1 Extender currently. Check the box before each MAC
address, click “Add” to add one or more available CPE(s) into the “Trusted CPEs” and click “Apply”
to save settings.
Add New CPE Manually
Enter the MAC address of the CPE that you would like to list into the access control list, click “Add”
then the CPE will be added into the “Trusted CPEs”.
Trusted CPEs
Check the box before one or more MAC addresses of CPEs that you would like to cancel, and click
“Delete” to cancel that access control rule.