User's Manual

5
Chapter 2 Hardware Installation
This chapter describes initial setup of the 802.11g SMB Wireless Access Point.
2-1 Package Contents
The package you have received should contain the following items: If any of the above items
are not included or damaged, please contact your local vendor for support.
• 802.11g SMB Wireless Access Point…………………………...……………..x1
• Power Adapter…………………………………………………………………x1
• Product CD… .…………………………………………………………………x1
• The User Manual… ...………………………………………………………….x1
2-2 System Requirements
Before installing the 802.11g SMB Wireless Access Point, please make sure that these
requirements have been met:
n A 10/100 Mbps Local Area Network device such as a hub or switch.
n Category 5 networking cable.
n An A/C power adapter (12V, 1.2A).
n A Web browser for configuration: Microsoft IE 4.0 or above, or Netscape Navigator 4.5
or later version.
n Installing TCP/IP protocol to the computer.