User Manual

Attention: When using a SD or SSD on Z CAM E2C for the first time, please format
it on the computer in exFAT format, and then format it in the camera.
• Assist Tools: There is three sub-items in this setting: Display / Scope / Peak /
Exposure / Frame Line / Center Mark / Grid Line / Safe Area
n Display: On / Off. To enable or disable the assist tool on the display. Please
note that when the assist tool is enabled, the effect will be output through HDMI
together with the video stream. So you would need to turn it off if you are using
external recorder though HDMI connection.
n Scope: Tool / O pa c i t y / Measure
- To o l : Disable / Waveform / Parade / Vectorscope / Histogram, for HDMI
output only
- Opacity: 10~100, adjust the tool’s brightness on the monitor when it’s
enabled.
- Measure: Without LUT / With LUT, if it's set to ” With LUT”, then the scope
tool will measure on the video with LUT, otherwise it will measure the video
without LUT.
n Peak: Enable / Color
- Enable: On / Off, to enable / disable the Peak tool and set the color of
peaking focus.
- Color: Red, Green, Blue, Orange and White, choose the color of peaking
focus display.
n Exposure: Tool / Zebra1 Setting / Zebra2 Setting
- Too l : D is a b le / F als e C o l o r / Wa v efo r m / Z e bra / Ve c t ors c o pe
Select the appropriate exposure assist tool or turn it off. The false color/
waveform / vectorscope are only displayed on the HDMI output screen.
- Zebra1 setting: 55~100, it can only be set when the tool is selected as
"zebra".
- Zebra2 setting: 0~50, it can only be set when the tool is selected as
"zebra".
n Frame line: Ratio / Color
- Ratio: None / 2.4:1 / 2.35:1 / 1.9:1 / 1.85:1 / 4:3 Frame line can be
displayed on the HDMI output screen according to the selected ratio.
- Color: Red, Green, Blue, Orange and White, can choose the color of frame