User guide

VIRTUAL H.264 8/16 CH DVR USER GUIDE

3-3. Setup – Recording Mode

Set the values for recording video. Navigate through menu items by pressing <UP> or <DOWN> button. User can

change the value of the menu item by pressing <LEFT> or <RIGHT> button.

Menu Items In Recording Mode Setup

Menu item Description

RESOLUTION

Set the resolution among 704x480, 704x240, or 352x240 for

NTSC. (PAL: 704*576/ 704*288/ 352*288)

CHANNEL

Select the channel to apply the following settings. Changes will

immediately appll to the selected channel.

FRAME RATE

Set the frame rate for the specified channel. The sum of the frame rate

values from each channel cannot exceed the maximum frame rates for a

specific recording resolution.

120fps(CIF) / 60 fps(Half-D1) / 30 fps(D1)(NTSC)

100fps(CIF) / 50 fps(Half-D1) / 25 fps(D1)(PAL)

QUALITY

Select the recording quality for the specified channel from NETWORK /

STANDARD / HIGH / SUPERIOR / ULTRA.

RECORDING

Set a recording mode for each channel.

Continuous / Motion / Sensor / Schedule / Disable.

MOTION ZONE

Select Full Zone or Partial Zone for motion sensing.

MOTION SENSITIVITY

Set the motion sensitivity for the specified channel.

Adjust the motion sensitivity from 1 to 9.

SENSOR RECORDING

Enable setting up to 4 sensors for the specified channel.

PRE RECORD

Enable/disable pre-event recording. Pre-event recording time is 3 seconds

and only intra-frames are recorded for pre-event recording.