Declaration of Conformity

English
3 – 4
Description Assembly/operation
 LEDs for the groups
(A, B, C, D)
 Buttons for the group selection
 Manual release button
 Increasing the performance
- Tap: Light performance is increased in . steps
- Keep pressed down: Switching to modelling light by tapping
the performance of the modelling light is increased
 Reducing the performance
- Tap: Light performance is reduced in . steps
- Keep pressed down: Switching to modelling light by tapping
the performance of the modelling light is reduced
 Base connector
 DIP switch in the battery compartment for setting the channel
 Battery compartment with lithium battery CR
 Switch off the camera and ST- before assembly or disassembly.
 Turn the knurled nut fully against the ST- .
The locking pin in the base connector is now fully inserted into the
trigger housing.
 Slide the Studio Trigger with the base connector to the stop in the
accessory shoe on the camera.
 Turn the knurled screw against the camera body until it clicks into
place and clamp the ST-.
On camera bodies without a locking hole, the spring-mounted lock-
ing pin sinks into the housing of the Studio Trigger, as a result the
surface is not damaged.
For disassembly, proceed in the reverse order.
Observe the safety instructions before start-up! Switch o the Studio
Trigger before assembly or disassembly.
.
.
.
.