User Manual

11
y Inspect each component and, if required, repeat washing until visually
clean, making sure there is no soap residue.
y Rinse all components well with drinking quality water and allow to air dry
out of direct sunlight.
y When all components are dry, reassemble according to the reassembly
instructions.
y Hand washes the headgear and all components in warm (approx. 30°C) and
soapy water. Use pure soap. Rinse the components well and allow them
to air dry out of direct sunlight.
y This action will age or damage the mask and shorten its service life. If any
visible deterioration of a mask component is apparent (cracking, crazing,
tears etc), the mask component should be discarded and replaced.
CAUTIONS
The mask is for single-patient use in the hospital or institutional environment.
If the mask gets dirty during use, please use disposable medical cleaning
cloth or paper to clean out visible dirt, and then rinse mask well with
drinking quality water and allow to air dry out of direct sunlight.
Problem Possible cause Solution
Mask is too noisy
Vents are blocked or
partially blocked.
Mask is assembled
incorrectly.
Clean vents according to
Instructions in “Cleaning
the Mask at Home”.
Reassemble mask.
Mask leaks around
the face.
Mask may have been
fitted incorrectly.
Carefully follow
instructions in“Fitting”.
T
r
oublesho
o
ting
U
se
the
Mask
in
the
H
o
spi
t
al
or
In
s
titutional
envi
r
onment
Weekly