Operator`s manual

Alignment tab:
MantraJet 1100 and any other printer is a mechanical device. This is why sometimes a
minor misalignment may occur due to the handling of the printer in shipping.
MantraJet 1100 allows correcting the undesired offset of the printable area.
The best method is to use the “Test print” in the “Utilities” tab.
The printed disc has a circle of 116 mm diameter. If the circle is offset you can simply
enter the desired offset and click on “Offset” button.
Use negative value of X axis offset when you want to shift the image to the left side and
positive value when offset to the right side is needed.
Use negative offset of Y axis offset when you want to move the printed image to the top
and positive value when offset to the bottom is required.
NOTE: Clicking on OK or Apply button does not change the center offset.
You can use the “Default offset” button to return to factory default offset of the printer.
19