User Manual

After sliding the icon, the remote control interface will display EXIT and [ ]. When
the pilot tap the [ ]， the icon will become [ ]. Then the journey function is
paused. When the pilot taps it again, the [ ] will become [ ], the copter will
continue the journey function. The pilot can exit the function by tapping EXIT icon
or switching flight mode.
NOTICE:
When the Journey function is activated, the Journey distance can be set
by the pilot.
NOTICE:
The gimbal camera can't be controlled when journey function is
activated and will remain the previous angle set before. Depending on the camera
tilt, the aircraft will go up and out to take the perfect selfie.
1/3
2
JOUR: Journey function enables Typhoon H to capture the perfect aerial
selfie much easier. Depending on the pilot's desired setting, Typhoon H
will go up, out and return.
Tap JOUR to enter the journey function.
START: Press START, and slide the icon. Typhoon H will fly up and out and then take a selfie.
BACK:
Tap BACK to return to the previous interface.
ORBIT ME:
When Orbit Me is enabled, Typhoon H flies a circular path
around the pilot.
Press ORBIT to enter the ORBIT ME function.
START:
Press START, and slide the icon, push the aileron stick to the right or left,
then Typhoon H will fly around the pilot with the distance between the start point
and the pilot as the radius.
BACK:
Tap BACK to return to the previous interface.
NOTICE:
You can increase/decrease radius by apply forward/back on right stick.
You also can trim the gimbal pan position by adjusting pan control knob on ST16.
CENTER:
Press CENTER to set the current flight position of Typhoon H as the center of a circle.
START:
Press START, and slide the icon, push the aileron stick to the right or left,
Typhoon H will fly around the circle center with distance between the Start point and
the center point as the radius.
BACK:
Tap BACK to return to the previous interface.
NOTICE:
You can increase/decrease radius by apply forward/back on right stick.
You also can trim the gimbal pan position by adjusting pan control knob on ST16.
POI: Point of Interest allows the pilot to select a subject they would like
to orbit and have Typhoon H orbit that subject autonomously.
11