User Manual
ADDITIONAL FUNCTIONS:
NOTICE: Users can control pitch, roll and yaw directions during descent. The Typhoon
H will hang over the home position at the current height when RC signal is lost.
CAUTION:
You must be certain there are no obstacles in the ‘Return to Home’ flight path
otherwise Typhoon H may come into contact with them and crash. While
Typhoon H is in Home Mode you will have a limited amount of directional
control. To help avoid obstacles we strongly recommend to switch to Smart or
Angle Mode (then you can switch back to Home Mode).
If the PAN mode of the gimbal camera is switched to Follow and Follow Pan
Controllable modes, the gimbal PAN and TILT angle will be adjusted as the same
as the angle what the gimbal camera is at each waypoint automatically and
continuously. When the PAN mode is switched to the Global Mode, the PAN and
TILT angle can be controlled by aileron and elevator stick.
NOTICE:
The direct distance between every two waypoint should be more than 5 meters.
If the pilot set 7 waypoints as shown, when the copter arrives at the Waypoint 1,
slowly raise the throttle stick, the copter will fly along the waypoints from 1 to 7 in
order. If the pilot slowly lower the throttle stick, the copter will fly along the
waypoints from 7 to 1 in order.
ADVANCED MODES
Tap the [ ] and choose Other Settings on the ST16 Ground Station,
turn on the Advance Mode, and tap the return button [ ]. After, tap the
TASK/CAMERA icon, the background of 'TASK' will become orange, then you will
enter another interface displaying five functions: CCC (Curve Cable Cam),
Journey, POI (Point of Interest) , ORBIT ME functions and take off.
6
7
1
2
3
4
5
CCC: (Curve Cable Cam) Curve Cable Cam allows you to create an
invisible route for Typhoon H to fly along. Once the pilot sets the point,
Typhoon H will fly the set coordinates while remembering the heading.
Tap the CCC to enter the Curve Cable Cam function.
BACK: Tap BACK and you can return to the previous interface.
RESET:
Tap RESET to delete all the points created during the flight.
:
Tap '-' to delete the last point created during the flight.
:
Tap '+' to create a new point recording the current flying position.
LIST:
Tap LIST and all previous routes will be shown on a list. You can delete any
saved route by sliding the chosen one to the left.
SAVE:
Tap SAVE and the current route will be saved.
START:
Tap START, and slide the icon. Typhoon H will fly back to waypoint 1
automatically.
Model: Typhoon H welcome,Pilot 12:27 AM 12
VOLTS
GPS
SAT
POS
ALT
G-SPD
DIS
N/A
N/A
N/AE
N/AN
N/AV
N/Am
N/A KPH
N/Am
System SengsPad
Channel Sengs
Model Select
TASK
CAMERA
GPS
CALIBRATION
FOLLOW
WATC H
ANGLE
G
Disabled
OBS
BACK RESET LIST SAVE
START
SLIDE TO START
CANCEL
Make sure the H is clear of all
obstacles before starting mission.
CCC
PONINT 1PONINT 1
PONINT 2
PONINT 3
INSTRUCTION
RESET: Delete all waypoints
+/-: Add/Delete a waypoint
LIST: Load existing waypoint
SAVE: Save waypoint
START: Start waypoint mission
BACK RESET LIST SAVE
START
10
TASK MODES
WARNING: Home Mode only works when Typhoon H has a suitable GPS
signal/lock. If Typhoon loses GPS signal/lock it will switch to Angle (Pilot) Mode
automatically. This is why we strongly recommend learning to fly in Angle (Pilot)
Mode as soon as possible. Otherwise, if you lose GPS signal/lock and are not
able to properly control Typhoon H in Angle (Pilot) Mode the aircraft may crash
or even ‘fly away’.
System Sengs