V12242015
IMPORTANT NOTE This Quick Start Guide will show you the basis of capturing life’s most incredible moments. However, it is NOT intended to replace the content included in the instruction manual. You should read the instruction manual completely before proceeding. GENERAL WARNINGS: IMPORTANT NOTE: All safety precautions and warnings, instructions, warranties and other collateral information is subject to change at the sole discretion of Yuneec.
CAMERA Do not expose the CGO4 gimbal camera to water, including rain and moisture. Do not expose the lens of the CGO4 gimbal camera to excessive light sources. Do not operate the CGO4 gimbal camera in environments with extremely high or low temperatures and high humidity. Do not try to repair the CGO4 gimbal camera by yourself.
CAMERA Image Sensor: m4/3 live CMOS sensor Effective Pixels: 16 Megapixels Max Video Resolution: 4K 30FPS,100 Mbps Digital video Downlink: Integrated Compatible Lens: 3x optical zoom14-42mm(standard configuration), OLYMPUS M.ZUIKO DIGITAL ED 12mm f2.0 OLYMPUS M.ZUIKO DIGITAL 45mm f1.8 OLYMPUS M.ZUIKO DIGITAL ED 14-42mm F3.5-5.6 EZ Focus Mode: AFS/MF Shutter Speed: 1/8000s to 60s ISO Range: 100 to 25600 Shutter System: Focal- plane shutter GIMBAL Dimension: 6.5x8.6x7.
CAUTION: Power off the camera before inserting or removing the SD card. STEP 1: Remove the rubber SD card cover as shown in the illustration. STEP 2: Slide the memory card into the card slot in accordance with the direction indicated by the sticker. STEP 3: When fully inserted, the card clicks into place.To remove the card, place your fingernail against the edge of the memory card and lightly press it further into the camera. The card springs out far enough to be removed.
Dowels Damping Carbon Plate Damping Plate Rubber Dampers ATTACHING CGO4 GIMBAL CAMERA TO MULTICOPTER NOTICE: Remove the fixed foam pad from the CG04 gimbal camera before proceeding. STEP 1：Insert the gimbal connection cord to the inner side of gimbal damping plate (relative to the direction of H920 power connection port). STEP 2：Mount the gimbal thumb screws and lock washers (4 pcs) to the gimbal and rotate the screws until they’re secured into the gimbal damping plate.
LED STATUS INDICATION PROACTION™ (Control Status Indication) Boot Self-inspection: LED blinking red and blue alternately Double Hands Operating: LED solid red Single Hand Gimbal Gripping: LED solid blue PROACTION™ (Power Status Indication) First Level Low Voltage Battery Warning: LED blinking green slowly Second Level Low Voltage Battery Warning: LED blinking green quickly CGO4 (CAMERA) ST24 and gimbal camera not connected: LED blinking green.
GIMBAL CONTROL ON MULTICOPTER NOTE: In single mode, the camera and copter operations are conducted all by one person. While in team mode, operations are conducted separately: The photographer is in charge of the camera operation and the pilot is in charge of the copter operation. In the following we will set single mode as an example. If the user wants to operate in team mode, please refer to the instruction manual.
When the self-check (start-up) process has been completed, the Control Cue Light will grow solid blue. The user can switch freely between Follow Mode and Global Mode without powering off the gimbal. FOLLOW MODE In Follow Mode, the camera lens moves in the direction of ProAction™. The user can only manipulate the pitch direction through Gimbal Control Stick on the right. If the Gimbal Control Stick moves upward, the camera lens will trim itself up.
NOTICE: When in the Follow Mode,the Gimbal Control Stick can't control the CGO4 in Yaw axis. When in the Global Mode, the Gimbal Control Stick can control the CGO4 in Pitch and Yaw axes. SINGLE HAND OPERATING Lift the center carrying handle with one hand. When holding the ProAction™ with singlehand,press and hold the Function Switch Button in the rear of the Pitch Control Wheel. The Control Status Indicator will glow solid blue when successfully switched.
APP The APP seamlessly integrates control of CGO4 gimbal camera so that you can see exactly what your camera sees with a live HD video feed right on your mobile device. It makes you feel as though the camera is right in your hands. CAUTION: If the user wants to take photos or videos through ProAction™, CGO4 APP should be downloaded beforehand. APP DOWNLOADING Download the free APP named CGO4 to smart device at the APP Store or Google Play Store. Install the APP to your 5.8GHz Wi-Fi capable device.
FCC STATEMENT: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IC RADIATION EXPOSURE STATEMENT FOR CANADA This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
