Quick Start Guide
EN INTRODUCTION Breeze is a flying camera that is designed to take aerial photos and videos of you. It is small, easy to fly both indoors and outdoors, and is controlled by your smart phone or tablet computer. The application (Breeze Cam) features five custom automatic flight modes that make positioning Breeze very easy. Once you’re done flying, you can download photos and videos to your device and share them to your favorite social networks directly from the app.
Breeze 01 02 03 04 05 06 07 08 09 10 11 12 13 14 GPS Module Battery Locking Tab 11.
SPECIFICATIONS AIRCRAFT CAMERA Dimensions (without propeller protectors):196x196x65 mm Dimensions (with propeller protectors): 327x327x65 mm Diagonal Wheelbase: 240mm Takeoff Weight: 385g Propeller Protector: Quick-Release Propeller Protector Battery: 3-Cell 11.1V 1150mAh 12.
PREPARATIONS 1. CHARGING THE BATTERY (~45min) Battery Warnings: ・To charge the flight battery, you must only use the included charger. ・Do not over-discharge the LiPo battery. ・If at any time the LiPo battery begins to balloon or swell, discontinue charging or discharging immediately. ・Always terminate all processes if the battery/charger malfunctions. ・Store the LiPo battery at room temperature and in a dry area for best results.
3. UNFOLDING THE LANDING GEAR 4. INSTALLING THE PROPELLER PROTECTORS 5. INSTALLING THE FLIGHT BATTERY Unfold the four landing gears as shown in the below illustration. Install the four propeller protectors to the corresponding positions as shown in the illustration below. ・Slide in the fully charged battery until it locks. ・Remove the battery by pressing the locking tab and sliding the battery to the rear of Breeze.
6. POWERING ON/OFF BREEZE 7. BINDING BREEZE WITH YOUR SMART DEVICE POWER ON: To start your Breeze, press and hold the power button at the rear of Breeze. When Breeze is on, the LED indicator will blink blue-red-green four times and emit a sound. When the LED indicator blinks blue rapidly, Breeze will enter “bind” mode. Power on your Breeze on a flat and stable surface and wait for it to complete initialization. When the LED indicator blinks blue rapidly, Breeze has entered the “Wi-Fi” bind mode.
9. COMPASS CALIBRATION NOTICE: Only calibrate the compass in open areas/fields far away from cars, power lines and other metallic surfaces/structures. Make sure that your Breeze is placed level and about 1.5m (5ft) above the ground. Nor th 1.5m ( 5ft ) Step1 Tap [ ] and select Drone Settings, and then swipe the screen to “Compass Calibration”. Follow the on-screen animations to complete the calibration.
11. UNDERSTANDING THE FLIGHT MODES Tap the [ ] icon to enter the TASK page and there are five flight modes for you to select with: SWITCHED ON lifts off the ground surface, it will fly to default height(1 meter) and hover in space above the take-off point. R TAS KS 60 % PILOT 8 SELFIE ORBIT JOURNEY FOLLOW ME Before GPS is ready,only Pilot mode can be used. To bring Breeze back to the take-off point and auto land, tap [ ].
NOTICE AND WARNINGS Breeze may drift or fail to position when it flies indoors because the performance of the Indoor Positioning System can be affected by light intensity and ground texture. You should not operate Breeze in the following situations: 1. Flying over particularly sparse surfaces or surfaces without clear patterns/textures; 2. Flying over highly reflective surfaces or surfaces with reflections; 3. Flying over water or waterlogged surfaces; 4.
GENERAL WARNINGS 1. Breeze is not suitable for children under 14 years of age. 2. Breeze is designed for leisure purposes. The pilot must always maintain direct visual contact with Breeze and monitor its trajectory. Breeze must be used in accordance with the civil aviation regulations in your country. 3. Always operate your Breeze in open areas that are free from people, vehicles and other obstructions.
DISCLAIMER Yuneec Electric Aviation cannot be held liable for any damage, injury or for use of the product in violation with legal regulations, especially in the following circumstances: Damage and / or injury as well violation of legal regulations resulting from a failure to comply with the operating instructions or the instructions at www.yuneec.com, product information, user manual and other legally binding information.
missing parts. Damage and/or injury as well as violation of legal regulations caused by operating the model in a magnetic field (e.g. high voltage lines, electricity/transformer stations, radio towers, mobile phone masts etc.), a strong wireless signal environment,no-fly zones, poor visibility and in the event of vision impairments or other impacts on the pilot which are left unchecked etc.
FCC STATEMENT This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
IC RADIATION EXPOSURE STATEMENT FOR CANADA This device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
COLLECTION AND PROCESSING OF DATA Yuneec may collect navigation information such as GPS data to help improve our products. We may also collect Depth Map information and Infrared Image information from your drone delivered to our service center for repair and maintenance service or any other service. We may also collect other information such as device information, server log information, etc.
CUSTOMER SERVICE MANUFACTURER: Yuneec International (China) Co., Ltd. Production Address: East Zhengwei Road No.388, Jinxi Town, Kunshan City, Jiangsu Province DISTRIBUTOR: CN: Youyu (Shanghai) Digital US: Yuneec USA Inc. EU: Yuneec Europe GmbH Technology Co.,Ltd.
