User Manual
ADDITIONAL FUNCTIONS:
If the PAN mode of the gimbal camera is switched to Follow and Follow Pan
Controllable modes, the gimbal TILT angle will be adjusted as the same as the
angle what the gimbal camera is at each waypoint after the pilot set the waypoints
automatically and continuously. When the PAN mode is switched to the Global
Mode, the PAN and TILT angle can be controlled by aileron and elevator stick.
NOTICE:
The direct distance between every two waypoint should be more than 5 meters.
TASK MODES
Tap the TASK/CAMERA icon, the background of 'TASK' will become orange, then
you will enter another interface displaying functions: CCC (Curve Cable Cam),
Journey, POI (Point of Interest), ORBIT ME and TAKE OFF.
CCC:
(Curve Cable Cam) Curve Cable Cam allows you to create an invisible
route for Typhoon H to fly along. Once the pilot sets the point, Typhoon H
will fly the set coordinates while remembering the heading.
Model: Typhoon H welcome,Pilot 12:27 AM 12
VOLTS
GPS
SAT
POS
ALT
G-SPD
DIS
N/A
N/A
N/AE
N/AN
N/AV
N/Am
N/A KPH
N/Am
System SengsPad
Channel Sengs
Model Select
TASK
CAMERA
GPS
CALIBRATION
FOLLOW
WATC H
ANGLE
G
Disabled
OBS
BACK RESET LIST SAVE
START
SLIDE TO START
CANCEL
Make sure the H is clear of all
obstacles before starting mission.
CCC
PONINT 1PONINT 1
PONINT 2
PONINT 3
INSTRUCTION
RESET: Delete all waypoints
+/-: Add/Delete a waypoint
LIST: Load existing waypoint
SAVE: Save waypoint
START: Start waypoint mission
11
Tap the CCC to enter the Curve Cable Cam function.
BACK: Tap BACK and you can return to the previous interface.
RESET:
Tap RESET to delete all the points created during the flight.
:
Tap '-' to delete the last point created during the flight.
:
Tap '+' to create a new point recording the current flying position.
LIST:
Tap LIST and all previous routes saved will be shown on a list. You can delete
any saved route by sliding the chosen one to the left.
SAVE:
Tap SAVE and the current route will be saved.
START:
Tap START, and slide the icon. Typhoon H will fly back to waypoint 1
automatically.
BACK RESET LIST SAVE
START
[ ]: When the pilot tap the [ ]， the icon will become [ ]and the CCC function
will be paused. When tap it again, the [ ] will become [ ], the copter will continue
the CCC function. The pilot can exit the function by tapping EXIT icon or switching
flight mode.