User Manual

for all other operating configurations, including portable configuration with respect to Part 2.1093
and different antenna configurations.
A module or modules can only be used without additional authorizations if they have been tested
and granted under the same intended end‐use operational conditions, including simultaneous
transmission operations. When they have not been tested and granted in this manner, additional
testing and/or FCC application filing may be required. The most straightforward approach to address
additional testing conditions is to have the grantee responsible for the certification of at least one of
the modules submit a permissive change application. When having a module grantee file a
permissive change is not practical or feasible, the following guidance provides some additional
options for host manufacturers. Integrations using modules where additional testing and/or FCC
application filing(s) may be required are: (A) a module used in devices requiring additional RF
exposure compliance information (e.g., MPE evaluation or SAR testing); (B) limited and/or split
modules not meeting all of the module requirements; and (C) simultaneous transmissions for
independent collocated transmitters not previously granted together.
This Module is full modular approval, it is limited to OEM installation ONLY.
Integration into devices that are directly or indirectly connected to AC lines must add with Class II
Permissive Change. (OEM) Integrator has to assure compliance of the entire end product include
the integrated Module. Additional measurements (15B) and/or equipment authorizations (e.g.
Verification) may need to be addressed depending on co-location or simultaneous transmission
issues if applicable. (OEM) Integrator is reminded to assure that these installation instructions will
not be made available to the end user
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
IC labeling requirement for the final end product:
The final end product must be labeled in a visible area with the following “Contains IC: 11554B-
YUNOFDM”
The Host Marketing Name (HMN) must be indicated at any location on the exterior of the host
product or product packaging or product literature, which shall be available with the host product
or online.