User's Manual

FCC warnings:
FCC Statement:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
RF Exposure Information:
This equipment complies with FCC SAR limits set forth for an uncontrolled environment .This
equipment must be installed and operated in accordance with provided instructions and the
antenna(s) used for this transmitter must be installed to provide a separation distance of at least
10mm from all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter. End-users and install-ers must be provided with antenna installation
instructions and transmitter operating conditions for satisfying RF exposure compliance.
ISED RSS Warning/ISED RF Exposure Statement:
ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
ISED RF exposure statement:
This equipment complies with ISED SAR limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 10mm between the
radiator & your body.This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
Cet équipement est conforme aux limites ISED SAR définies pour un environnement non
contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 10 mm
entre le radiateur et votre corps. Cet émetteur ne doit pas être placé au même
emplacement ni être utilisé avec toute autre antenne ou émetteur.
For Mantis G Remote Controller
27