User's Manual
ST16 INSTRUCTIONS
CHARGING THE LI-ION ST16 ProrROrtp ro BATTERY
You can charge the ST16 Pro battery by using supplied USB cable and inserting it
into the USB port on the charger. A green blinking LED indicates the charger
is powered on and ready to charge, and a red blinking LED indicates the
baery is charging. It will take approximately 5 hours to charge a fully
discharged (not over-discharged) baery. A solid green LED indicates the
baery is fully charged.
NOTE: The AC plug type will vary depending on the region in which the
product was imported/purchased (AU = Australian; EU = European; UK =
United Kingdom; US = United States).
TAKING PHOTOS AND RECORDING VIDEO
TO TAKE A STILL PHOTO
Press the button located near the top left corner of the ST16 Pro. You’ll hear
an audible ‘shutter’ sound from the ST16 Pro and the LED indicator on the
front of the camera will change from glowing solid green to glowing solid
blue. It will take approximately 1-2 seconds to capture the photo and
before you can take another sll photo.
TO START/STOP RECORDING VIDEO
Press the button located near the top right corner of the ST16 Pro. You’ll hear
an audible indication from the ST16 Pro each time the recording starts/stops.
And while video is recording the LED indicator on the front of the camera
will flash blue and green, and there will be a red dot next to the me length
of the recording near the upper right-hand corner on the screen of the
ST16 Pro.