User's Manual

ST16 INSTRUCTIONS
CHARGING THE LI-ION ST16 BATTERY
You can charge the ST16 baery by using supplied USB cable and inserng it
into the USB port on the charger. A green blinking LED indicates the charger
is powered on and ready to charge, and a red blinking LED indicates the
baery is charging. It will take approximately 5 hours to charge a fully
discharged (not over-discharged) baery. A solid green LED indicates the
baery is fully charged.
NOTE: The AC plug type will vary depending on the region in which the
product was imported/purchased (AU = Australian; EU = European; UK =
United Kingdom; US = United States).
TAKING PHOTOS AND RECORDING VIDEO
TO TAKE A STILL PHOTO
Press the buon located near the top le corner of the ST16. You’ll hear
an audible ‘shuer’ sound from the ST16 and the LED indicator on the
front of the camera will change from glowing solid green to glowing solid
blue. It will take approximately 1-2 seconds to capture the photo and
before you can take another sll photo.
TO START/STOP RECORDING VIDEO
Press the buon located near the top right corner of the ST16. You’ll hear
an audible indicaon from the ST16 each me the recording starts/stops.
And while video is recording the LED indicator on the front of the camera
will flash blue and green, and there will be a red dot next to the me length
of the recording near the upper right-hand corner on the screen of the
ST16.