Quick Start Guide

Step 1.
Switch on the ST16S followed by the aircraft.
Step 2.
Ensure no Wifi is connected to the ST-16S remote
controller, then tap [ ]on the top right corner on
the main interface of ST16S.
Select Vehicle to Connect
NO CAMERA
E30Z-B1004C
Fly
Takeoff
RTL
Pause
Action
Reset All Links
Close
Not Connected
N/A
75%
GPS
Cancel
ok
Please enter password for
E30Z-B1004C
NO CAMERA
E30Z-B1004C
Fly
Takeoff
RTL
Pause
Action
Reset All Links
Close
Not Connected
N/A
75%
GPS
NO CAMERA
Fly
Takeoff
RTL
Pause
Action
Not Connected
N/A
75%
GPS
Binding the E30Z and H520
NOTICE
If the connection process is delayed, close the pop
up window and then repeat the above steps.
Step 3.
Tap the SSID of the E30Z when the following
window pops up. If multiple Yuneec UAS are used,
check the ID number on damping plate to assure
correct camera selection/binding.
Step 4.
Use the password “1234567890”, authorize the
camera and tap "OK" to confirm.