3-Axis Gimbal Camera QUICK START GUIDE V1.
Introduction and Overview 01 02 06 03 04 05 07 01 02 03 04 05 Connection Pin Damping Plate LED Status Indicator Camera Camera Lens 06 Micro SD Port 07 5GHz Antenna
Specifications General Camera Product:3-Aix Gimbal Camera Model Name: E30Z Dimensions:5.8X4.2X5.7inch( 148.4X105.6X144.8mm ) Weight:21.0oz ( 595g ) Sensor: 1/2.8"CMOS Effective Pixels: 2.13MP Lens: F1.6(Wide)-F4.7(Tele) FOV: 63.7°(Wide)-2.
Gimbal Installation Assembling Step 1. Find the arrow printed on the top of the damping plate, which indicates the correct direction for installation. Step 2. Slide the E30Z in the indicated direction all the way into the mounting slot, until the E30Z is secured by the locking clip. Step 3. Remove the lens protector. Step 4. Insert the Micro SD card. Disassembling Step 1. Find the locking clip which is located in front of the mounting slot. Step 2.
Not Connected Step 1. Switch on the ST16S followed by the aircraft. 75% GPS Binding the E30Z and H520 N/A Fly NO CAMERA Takeoff RTL Step 3. Tap the SSID of the E30Z when the following window pops up. If multiple Yuneec UAS are used, check the ID number on damping plate to assure correct camera selection/binding. Pause Action Not Connected 75% GPS Step 2. Ensure no Wifi is connected to the ST-16S remote controller, then tap [ ]on the top right corner on the main interface of ST16S.
Zoom Zoom in Press and hold the zoom in button to increase the optical zoom. When increasing to 30X optical zoom, if press the zoom in button again, the camera begins to increase digital zoom. The digital zoom can increase to 6X at the most. ZOOM IN Zoom out ZOOM OUT Press and hold the zoom out button to decrease the optical zoom. When decreasing to 1X digital zoom, if press the zoom out button again, the camera begins to decrease optical zoom.
NOTICE 1 Make sure that the firmware of the gimbal has been updated to the latest version. 2 For the latest product information, please check our official website: www.yuneec.com.
subpoena, warrant or request from government, or otherwise cooperating with government agencies or law enforcement.
signal environment, no-fly zones, poor visibility and in the event of vision impairments or other impacts on the pilot which are left unchecked etc. Damage and/or injury brought about through a violation of the legal regulations for operating the model, in unsuitable weather conditions, e.g. rain, wind, snow, hail, storms, hurricanes etc. Damage and/or injury as well as violation of legal regulations caused by force majeure, e.g.
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
Customer Service Manufacturer: Yuneec International (China) Co., Ltd. Address: East Zhengwei Road No.388, Jinxi Town, Kunshan City, Jiangsu Province, China Distributor: CN: Yuneec International (China) Co., Ltd. Address: East Zhengwei Road No.388, Jinxi Town, Kunshan City, Jiangsu Province, China Tel.: +86 400 8207 506 saleschina@yuneec.
