User's Manual

AERIAL IMAGING SOLUTION

ATTACHING CGO4 GIMBAL CAMERA TO MULTICOPTER

STEP 1)： Mount the Rubber Dumpers to H920 fixing eyelet, install the two thread-off proof

screws to fix the gimbal damping plate and then tighten all the screws.

STEP 2)：Insert the Gimbal Connection Cord to the inner side of Gimbal Damping Plate

(relative to the direction of H920 Power Connection Port)

STEP 3)：Mount the Gimbal Thumb Screws and lock

washers (4 pcs) to the Gimbal and rotate the screws until

they’re secured into the Gimbal Damping Plate.

STEP 4)：Connect the Gimbal Power Cord to H920 Power

Connection Port.

NOTICE: The “Front” of the gimbal camera should be

installed in the direction of the nose of H920.

NOTICE: Use the dedicated lock washers when rotating the screws

BINDING CGO4 GIMBAL CAMERA TO THE ST24 (SINGLE MODE)

STEP 1): Power on the ST24, press [ ] button to go to the main interface. Choose FPV, and

enter Model Select.

STEP 2): The default Model type is Multi-copter. Tap the “H920 CGO4” icon and press OK to

enter the flight control interface.

NOTE: The pre-set model in the “Model Select” interface cannot be deleted.

NOTE: The pre-set model can only be bound to one multi-copter. If the user wants to bind to

the other copters, press and hold the “H920 CGO4” icon, select “copy” on the pop-up menu.

Wait for a few seconds and then tap the newly created icon. Press OK to enter the flight

control interface.

STEP 3): Switch on the TORNADO H920. Wait for a moment until the H920 Main LED indica-

tor blinks blue, the CGO4 LED indicator blinks green and

then start the binding procedures.

STEP 4): Lean the H920 in the forward direction twice

(45°), until the Main LED indicator blinks yellow.

STEP 5): Tap the Refresh icon, and the codes of the H920

and CGO4 will be shown on screen. Choose the right

codes and press Bind.

STEP 6): If it is the first time to bind your CGO4 to the

ST24, you need to insert the password: 1234567890. Press OK on the pop-up window to continue.

STEP 7): Press Camera Select and choose CGO4. Press Select, then press OK.

CGO4

STEP 2 STEP 5

NOTICE: We recommend users to power on the aircraft in the angle mode.

NOTICE: When returns back to the FPV interface, you will hear two long beeps. That means

the binding is complete. The Real-time images can now be seen on the screen.