User's Manual

SD CARD INSTALLATION
NOTICE: Before photo-taking, SD card should be fully inserted into the camera. (The SD card
is not included in the package.)
CAUTION: Power off the camera before inserting or removing the card.
STEP 1): Remove the rubber bumpers.
STEP 2): Slide the memory card into the card slot in
accordance with the direction indicated by the sticker.
STEP 3): When fully inserted, the card clicks into place.
To remove the card, place your fingernail against the
edge of the memory card and lightly press it further into
the camera. The card springs out far enough to be
removed.
CAUTION: Keep the Memory Card out of the reach of
children to prevent swallowing.
LED STATUS INDICATION
PROACTION™ (Control Status Indication)
Boot Self-inspection: LED blinking red and blue alternately
Double Hands Operating: LED solid red
Single Hand Gimbal Gripping: LED solid blue
PROACTION™ (Power Status Indication)
First Level Low Voltage Battery Warning: LED blinking green slowly
Second Level Low Voltage Battery Warning: LED blinking green quickly
CGO4 (CAMERA)
ST24 and gimbal camera not connected: LED blinking green.
ST24 and mobile device connected: LED blinking blue
CGO4 Wi-Fi malfunction: LED blinking red
CGO4 (GIMBAL)
Firmware update in progress: LED blinking blue
Firmware update succeeds: LED blinking green
Firmware update Fails: LED blinking red
Powering On: LED solid blue for 7 seconds
Initializing: LED blinking blue and green alternately
Connecting Between the Gimbal and Aircraft Fails:
In the Follow Mode: LED blinking green
In the Global Mode: LED blinking blue
NOTICE: We suggest that the user restart H920/ProAction in such conditions.
Connecting Between the Gimbal and Aircraft Succeeds:
In the Follow Mode: LED solid green
In the Global Mode: LED solid blue
CGO4 (RECEIVER)
Receiver and ST24 connected: LED blinking red ( 2 times per second)
Receiver binding to ST24: LED solid red
Signal loss: LED blinking red (1 flash per second)
4