User's Manual

BINDING H920 MULTICOPTER TO THE ST12 (TEAM MODE)

STEP 1): Power on the ST12 and tap “RC” on the main interface

STEP 2): Tap Model Select and if required press “OK” to bypass any pop up warning/alerts.

STEP 3): Tap to create a new model and if required press “OK” to bypass any pop up

warnings/alerts.

STEP 4): Tap Flight Settings and if required press “OK” to bypass any pop up warnings/alerts.

STEP 5): Lift the H920 back end upward approximately 45° , then back down to “level” twice

till the main LED indicator blinks yellow.

STEP 6): Tap the Refresh icon. Select the code of the H920 listed in the column under

”Model” and tap Bind ,then tap “OK” after the connection has been established

STEP 7): When tapping, you will hear two long beeps from the aircraft. That means the ST12

is bound to the H920 successfully.

CAMERA CONTROL ON MULTICOPTER (TEAM MODE)

GIMBAL PITCH CONTROL

There is a gimbal pitch mode switch on ST24---S1. When the switch is in up/middle position,

the gimbal camera is in Angle Mode. Use K5 to set the pitch/tilt position of the gimbal

camera. When the S1 is in bottom position, the gimbal camera

is in Velocity Mode. When the right-hand stick is in the middle

position, it means the velocity rate is 0 for the CGO4, and it

will stop pitching up/down. When the right-hand stick is above

the middle position, the CGO4 will start pitching up. When the

right-hand stick is below the middle position, the CGO4 will

start pitching down. The distance between the right-hand stick

and the middle position decides the velocity rate, the further

distance, the higher velocity it would be.

GIMBAL YAW CONTROL

There is a gimbal yaw mode switch on ST24---S2. When the switch position is up, the gimbal

camera is in Follow Mode. The yaw control of the gimbal camera is now disabled; when the

switch is in the middle position, the gimbal camera is still in Follow Mode, however, at this

time, the yaw control is activated. The gimbal camera will adjust its yaw direction according

to the aircraft’s movements. When the switch position is down, the gimbal camera is in Global

Mode. The Aileron/Roll Control and Elevator/Pitch Control of the right-hand stick take

control of the CGO4 in yaw and pitch directions.

NOTICE: When the CGO4 is attached to the TORNADO H920, the control knob (K6) is

activated. Users can zoom in by rotating the knob (K6) in the clockwise direction (the move-

ment speed of the CGO4 gimbal camera in pitch and yaw directions will become slow in the

velocity mode), and vice versa (the movement speed of the CGO4 gimbal camera in pitch and

yaw directions will become fast in the velocity mode).

CAUTION: Each time the K6 is pushed to a certain position, it should be pushed back to the

middle position to confirm the setting. Otherwise, the gimbal camera will continue to zoom

in/out until it achieves the maximum/minimum value.

STEP 8):

Tap [ ] twice to return to the main screen and the model /receiver should automat-

ically connect to ST12

NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS

signal /lock. The H920 main LED indicator will be solid color of the current mode if the GPS

signal/lock is acquired.