User Manual

26
Your Dyno Watch comes with two different color watch bands. The watch bands are standard 22mm. The bands connect
to the watch with a spring bar, which passes through the loop hole in the band and fits into indents in the watch.
Removing the band
To remove the band, you need to remove the spring bar. To do this, you can use a spring bar tool, something similar, or
your hands. Insert the tool in between the band and where it connects to the watch and press the bar in (away from the
watch). This should push the spring bar down and release the band.
Attaching the band
Make sure the spring bar is threaded through the band. Take one half of the band, and carefully place the bottom part of
the spring bar into the indent in the watch. Then, compress the other side of spring bar so you can slide the rest of the
band into the indent on the other side of the watch.