Operation Manual

Operation of LED indicators
The left LED indicator (8) shows operational status of the unit.
The right LED indicator (9) shows operational status of the video recorder.
Open the plug and insert the SD memory card (6) as shown in Pic.2.
Activate the device by pressing the button “ON” (2). The left LED indicator (8) will light green.
Adjust the device following the instructions in the section “OPERATION”.
Turn on the video recorder by pressing the button “REC” (7) – the right LED indicator (9) will light up blue. The
video recorder will be ready in five seconds.
The display will show information on the battery charge , memory card and available recording
time . If there is no memory card in the device (NO CARD message on the display) or it is full (CARD
FULL message), the video recorder will automatically shut off and the right LED indicator (9) will go out.
To start video recording, press the “REC” button (7) - the right LED indicator (9) will start blinking.
Indication/recording and recording time counter will appear on the display.
Push the “REC” button (7) to stop video recording. The right LED indicator (9) will cease to blink.
To switch off the video recorder, keep the “REC” button pressed for two seconds – the right LED indicator will
go out.
Left LED Lights green The unit is on
Right LED
Lights yellow
Blinking green (yellow)
Lights blue
Blinking blue
The unit is on with IR
Low battery
The video recorder is on
Video recording is in progress