Operation Manual

8
7
To focus on the object being observed rotate the lens focusing ring (6).
After this adjustment no further dioptre adjustment should be required, regardless of distance or other
factors. Adjust the image with the lens focusing ring only.
Rotate the controller (3) to adjust display brightness: clockwise – to increase brightness;
counterclockwise – to decrease brightness. Brightness adjustment range is from 0 to 20.
In low light conditions or in complete darkness turn on the built-in IR Illuminator. Detailed description of
the IR operation is in section 10.
To focus the IR Illuminator, rotate the IR hood (13).
To activate the digital zoom, press twice and rotate the controller.
To start video recording, press briefly the REC (11) button.
10
The unit is equipped with IR Illuminator a wavelength of 850nm or nm 940 .
You can control the IR Illuminator in the VIDEO and PHOTO modes.
Upon powering on the IR Illuminator always turn on to its lowest power degree - IR1.
Setting IR Illuminator power level:
Press briefly the controller to unblock it - brightness, IR, and magnification icons appear on the
screen:
Press the controller to select icon IR.
BUILT-IN IR ILLUMINATOR
20
4.5x
IR1
To change power level (from 1 to 10), rotate the controller.
To turn the IR Illuminator off, rotate the controller to postion “off”. Upon turning the IR off, a crossed out
icon appears .
The power level of the IR Illuminator is not saved in riflescope’s memory.
To focus the IR spot, rotate the IR Illuminator hood (13).
In order to align the IR spot vertically or horizontally, turn the locking ring (12) 5-10 degrees
counterclockwise. Move the IR Illuminator hood (13) to match the spot with the image seen through the
riflescope. Tighten the locking ring (12).
/
* You cannot control the IR Illuminator when operating the unit in REVIEW mode.
Upon activation of REVIEW mode, the IR Illuminator switches off, the power level is saved, and the icon is
not shown on the display. Upon exiting REVIEW mode, the IR Illuminator reverts to the power level
selected before deactivation, with the corresponding icon shown on the display.
11
DIGITAL ZOOM FUNCTION
This function allows you to control the unit's ZOOM mode. The display shows the full magnification value
which is the production of the optical and digital magnification.
You can use the ZOOM function only in VIDEO and PHOTO modes.
To activate the zoom, briefly press twice the controller to select zoom icon (4.5x / 6x).
Cycle through the available full magnification options by briefly pressing the controller:
4.5x->9x->4.5x (4.5x models); 6x->12x->6x (6x models).
Setting retention. The digital zoom value is retained only during the current session.
When the unit is next switched on, the full magnification value reverts to 4.5x / 6x depending on the model.