Operation Manual

26
25
4) Release the REC button and the controller. The original
firmware is being installed which may take up to 1 min.
After successful firmware installation display will steadily glow.
5) Disconnect the riflescope from the power supply (remove
the batteries or disconnect an external power supply).
The riflescope will not turn off with the ON button.
6) The riflescope is ready to operate.
There are several
light or black dots
(pixels) on unit's
display.
Presence of dots is caused
by peculiarities of sensor or
display production
technology
and is not a defect.
This is not a defect.
Check
Corrective action
Problem
NOTES