User manual Sbach342 ALL-ENG

Seite 6
Best.-Nr. / Item-No. / art. 025-1060
Abschließend muss der Schwerpunkt am Modell über-
prüft werden. Dazu werden alle Komponenten (auch der
Akku!) im Modell montiert. Der Schwerpunkt liegt 53-57
mm hinter der Nasenleiste der Tragäche. Unterstützen
Sie das Modell mit zwei Fingern exakt an diesen Punk-
ten und beobachten Sie, wie das Modell auspendelt. Die
Nase des Modells sollte sich leicht nach unten neigen.
Dann ist der Schwerpunkt optimal justiert. / Before the rst
ight you have to check the center of gravity. For doing
so you have to mount all components (also the battery!)
in to the model. The CG is placed 53-57 mm behind the
nose cone of the main wing. Support the model exactly
at the marked spots on the bottom side of the wing. Put
the model on two ngers and watch the fuselage. The
nose should point slightly to the ground. Then the CG is
placed correctly! / Vericare il centro di gravità. Dovrete
usare il modello completo della batteria! Il CG è a 53-57
mm dietro il bordo d'entrata dell'ala. Tenere il modello tra
due dita come mostrato e guardate la fusoliera. Il muso
dovrebbe puntare leggermento verso il basso.
Wichtiger Hinweis / Special Note / ITA
Bei Modellen dieser Größe ist es besonders wichtig,
alle Maßangaben EXAKT(!) einzuhalten. Während bei
größeren Modellen Abweichungen von 1-2 mm durch-
aus akzeptabel sind, kann die gleiche Abweichung bei
kleinen Modellen extrem negative Auswirkungen auf die
Flugeigenschaften haben. Messen Sie daher die Ruder-
ausschläge und den Schwerpunkt SORGFÄLTIG(!) ein. /
When building models of this smaller size, it is especially
important, that all dimensions are EXACTLY(!) adjusted.
While tolerances of 1-2 mm are sometimes acceptable for
larger models, the same tolerance value will cause extre-
mely negative impact on ight characteristics at smaller
models. So you have to measure CAREFULLY(!) the
travels and the CG. / Nei modelli di dimensioni ridotte è
particolarmente importante di attenersi ESATTAMENTE
(!) a tutte le misure indicate. Mentre nei modelli più grandi,
tolleranze di 1-2 millimetri possono essere accettabili, le
stesse tolleranze nei modelli piccoli potrebbero avere degli
effetti estremamente negativi sul comportamento in volo.
Misurate e regolate sia le escursioni dei piani mobili sia il
baricentro con massima PRECISIONE!!
53-57mm
53-57 mm