User manual Sbach342 ALL-ENG

Seite 10
Best.-Nr. / Item-No. / art. 025-1060
General Safety Instructions For Electric Models
 This model is not a toy. Allowed for children over 14 years.
 Use the model accordingly to chapter 5 "How To Use" in this instruction manual.
 Assemble the model accordingly to this instruction manual. Do not alter or modify the model. Only use parts that are ofcially
recommended by KYOSHO Deutschland.
 Always pay close attention to the manuals that are included to accessory parts.
 Do not y the model before you have nished the assembly completely according to this manual.
 Before you y, check all functions of the model carefully. Check if your frequency is clear and not used by any
other pilots in your area. This may cause radio interference.
 Never y your model near other human beings, animals or other obstacles. You are responsible for ying the model, so
you have to check carefully your ight area.
 Stop ying immediately if you realize any radio interference. Check the system for the cuase and change the frequency
if necessary.
 Do not touch any moving or hot motor parts during action! Let all components cool down before you handle them.
 Check your model carefully after each ight. Replace parts if they are worn out or if they are defective.
 Keep your hands out of reach from rotating or hot parts of the model.
 Keep in mind that plastic parts easily break under cold temperature conditions.
 If you are a novice in ying you should ask experienced pilots for assistance during your rst ights.
 Protect yourself from dust and other small things when you test run your propeller drive on the ground.
 Keep all electronic components dry and clean!
 Take care that your motor does not get overload or gets blocked under full power.
 Let the motor cool down after restarting the model again.
 Charge your batteries carefully. Always watch the charging process and make sure all connectors are in good conditions.
 Do not shorten the battery by connecting the pluspole with the minuspole directly!
 Make sure that the wires do not touch rotating or hot parts of the model.
 CE-certication for electric motor: EN 50081-1, IEC 1000-4-2, IEC 1000-4-3, EN 50082-1
 In case of technical questions please contact our helpdesk by phone: [phone] or by e-mail: [e-mail]
5. Sicherheitshinweise / Safety Instructions / avviso di sicurezza