User's Manual

key switch on the transmitter; E2S turns the rotary key switch to the "on" position,
and E2M rotates the emergency stop button clockwise). Press the start button to
complete the boot action (or boot according to the set boot mode).
3. Follow the functions set by the buttons on the transmitter to operate
correctly.
4. After the operation is completed, proceed in the following order
1. Press the stop button (E2M presses the emergency stop button) /
2, remove the key switch (Note: E2S need to turn the rotary key switch to the
"pull" position, and then take out; E2B remove the key switch).
3 If it is not used for a long time, remove the battery inside the battery
compartment.
note
The transmitter has a power detection function and displays the power status
with LED indicators.
1. The green LED flashes to indicate that the battery is fully charged and the
transmitter can operate normally.
2. If the LED is steady red, the battery is low. At this time, you should pause
the work (for example, lower the hanging items to the ground) and update the battery
as soon as possible.
Receiver power supply
The F21-E2B receiver provides three kinds of transformers
(36V/220V/380VAC) for different power supplies. The required voltage is set at the
factory. Please confirm the required power before use.
Thirty-six, receiver wiring diagram
Six, qualified inspection form